Skin Graft Mesher Instruction Manual

Manual Content & Operating Procedures

Section 1: Setup & Pre-Operative Check

Inspection: Ensure the machine is free of debris and that the cutting rollers rotate smoothly without resistance.
Carrier Selection: Choose the appropriate graft carrier (e.g., 1.5:1, 3:1) based on the required expansion ratio.
Lubrication: Apply a drop of surgical-grade lubricant to the drive gears if necessary to ensure silent and smooth operation.

Section 2: Operating Instructions

Graft Placement: Place the donor skin graft (dermal side down) onto the carrier. Ensure the graft is flat and free of folds.
Feeding the Machine: Insert the leading edge of the carrier into the entry slot of the mesher.
Manual Rotation: Turn the hand crank in a steady, clockwise motion. Do not force the carrier; let the rollers draw it through at a natural pace.
Retrieval: Carefully remove the meshed graft from the carrier using fine-tipped forceps for immediate application to the wound site.

Section 3: Sterilization & Cleaning (The "Gold Standard")

Pre-Cleaning: Immediately after use, rinse the mesher with cool water to prevent blood and proteins from drying on the rollers.
Disassembly: If the model allows, remove the handle and rollers for deep cleaning. Use a soft-bristled brush to clean between the cutting teeth.
Autoclave Settings: * Temperature: 134°C (273°F).

Duration: 3 to 5 minutes (Pre-vacuum cycle) or 15 minutes (Gravity displacement).

Drying: Ensure the machine is completely dry before storage to prevent oxidation, even on high-grade stainless steel.

Derma Carrier Plates Sterile Packed.

Skin Graft Mesher Machine 1 Pcs
Dermacarrier II 3:1, Sterile 10 Pcs
Dermacarrier II 1.5:1, Sterile 10 Pcs
Dermacarrier II 6:1, Sterile 10 Pcs